 |
|
Knowledge Center
Product Documentation
|
|
Accessory Drive Gear 
Accessory Drive Gear converted from 8620 steel to Dura-Bar 65-45-12 ductile iron.
| Bearing Housing
Bearing Housing converted from 1018 steel to Dura-Bar 65-45-12 ductile iron.
| Flexible Shaft Coupling
Flexible Shaft Coupling converted from gray iron sand castings.
| Hydraulic Cylinder Piston
Hydraulic Cylinder Piston converted from steel to Dura-Bar 65-45-12 ductile iron.
| Manifold
Manifold converted to 65-45-12 ductile from hot rolled 1018 carbon steel.
| Motorcycle Disk Brake Rotor
Motorcycle disk brake rotor converted from stainless steel to Dura-Bar 80-55-06 ductile iron.
| Pulley
Pulley conversion from steel to Dura-Bar 65-45-12 ductile iron.
|
Density
Article with density calculations showing how the weight difference between Dura-Bar and steel can mean cost savings in shipping as well as weight reduction of the part itself.
| ISO Certificate
ISO 9001:2000
| Machinability
Article on free-machining and natural chip breaking characteristics of Dura-Bar. Graphite acts as a lubricant. Cost savings due to tool life and cutting speed.
| More Parts for Less Cost
Article from Fluid Power Journal: "Converting from Steel to Ductile Iron Yields More Parts for Less Cost".
| MSDS Austenitic Gray Irons
Material Safety Data Sheet for Austenitic Gray Irons
| MSDS Ductile and Gray Iron
Material Safety Data Sheet for Ductile and Gray Iron
|
Gear Brochure
Dura-Bar for Gears: Technical information on cost savings, performance and machinability.
| Quick Reference Guide
Overview of the Dura-Bar process, machinability, grades, properties, sizes and shapes.
|
Resource Guide Section 1 Introduction
Introduction to Dura-Bar, definition of cast iron and description of grades.
| Resource Guide Section 2 Gray Iron
Description of grades, typical applications and stock list.
| Resource Guide Section 3 Ductile Iron
Description of grades, typical applications and stock list.
| Resource Guide Section 4 Ni-Resist Iron
Description of grades, typical applications and stock list.
| Resource Guide Section 5 Heat Treating
Description of each type of heat treating, hardness measurements and growth.
| Resource Guide Section 6 Appendices
Tolerances, ASTM references, glossary, useful formulas/calculations, typical hardness value conversion table, and mechanical properties. |
|
|
|
|
|
|
|
|
|
|
